The World Leader in Aligment Parts, Tools & Education

error404 Contact Us
error404 Talk To an Expert
1-800-525-6505
error404
error404

APPLICATION SEARCH RESULTS

Make Model Sub Model Year(s) Drive Type
Rear Camber Rear Camber Tool Rear Toe Rear Toe Tool Front Caster Front Caster Tool Front Camber Front Camber Tool OE Replacement Notes

DON'T SEE A PART FOR THE VEHICLE YOU ARE SEARCHING?

Specialty Products is always looking for suggestions from Alignment professionals, Let us know what you are working on and what parts you need to be more productive.

ALIGNMENT FOOTNOTES:

N/A = No Available Adjuster(*) = Series P/N - View serires for correct size

  • (1) CAUTION: Check for caliper to rotor clear - ance with disc brakes. Use spacer set 75970 as necessary to keep caliper centered on rotor.
  • (2) All except RWD 1500 and LD2500 (7200 GVWR).
  • (3) Honda S2000 Ball Joint - Rear Application - Only for 17" rims or larger.
  • (4) Check Bolt Length BEFORE Cutting Hole
  • (5) Shims
  • (6) LH Tie Rod Adjusting Sleeve Replacement
  • (7) Bolts, 73415, are necessary for changes greater than 3/4°
  • (8) Recommended for vehicles lowered more than 1.5
  • (9) Will not work on 1988-89 models with welded-in ball joint
  • (10) M3 Only, caster will decrease by 2 degrees.
  • (11) Pinion Angle Adj. Part No. 82370
  • (12) Limited camber range of +/-1.0°
  • (13) Center stock camber and toe adjusters before calculating shim change
  • (14) 69330 or 69330 included w/ 69400
  • (15) Not for use w/disc brakes
  • (16) Can be used for Caster or Pinion Angle
  • (17) Footnotes 1 and 13
  • (18) Preferred
  • (19) Rear Pinion Angle
  • (20) Except Sti
  • (21) Series P/N, Not for use with ABS
  • (22) Lower Arm
  • (23) Except Type R Lower Arm
  • (24) Rear Wheel Drive Only
  • (25) 92-96 Only
  • (26) 92-98 Only
  • (27) C10 and C15
  • (28) Footnote 1, include the next part number
  • (29) Include the next part number
  • (30) With 10mm Bolt
  • (31) With 12mm Bolt
  • (32) All Except AMG models
  • (33) 1988-91 1500-43mm Bushings ONLY
  • (34) Models equipped with taller hydraulic bushings must be pressed out and reused from the original control arm or the 72360 trailling link can be used if applied.
  • (35) Except stamped sheet metal upper control arms
  • (36) Without Front Ride Height Sensor
  • (SW) Station Wagon
  • (L) Lower

These parts should only be installed by personal who have the necessary skill, training and tools to do the job correctly and safely.Incorrect installation can result in personal injury, vehicle damage and / or loss of vehicle control.

ON-SITE SERVICE

Please Note: While SPC does not offer direct on-site service of vehicles, our experienced techs are here to help answer any alignment questions you may have through our email form and FAQ section.